BASIC BED KIT
The Basic Bed Kit is an excellent solution for camper your VolksWagen Transporter T5 and T6 for very little money, in a few minutes without the need for tools and without the need to homologate in the I.T.V. This kit has the capacity to hold a 19-liter water tank as well as various compartments for all kinds of small waxes, clothes, etc
Wide Module Bed Kit
The Wide Module Bed Kit is designed to accommodate a 19 litre water tank and a fridge inside the modules, everything being under the bed totally hidden and integrated, your VolksWagen Transporter T5 or T6 a very complete camper van for very little money, in a few minutes without the need for tools and without the need to homologate in the I.T.V. Cheap camper vans.
Kitchen cabinet with sink, drawers and toilet space
Kitchen cabinet with 0.7 mm laminated worktop, scratch-resistant and waterproof, 100% with Dometic sink with glass lid, 42 cm diameter, two 19-litre tanks with submersible pump (included) with waterproofing of the storage area, two pull-out drawers 40 x 40 x 12 (width x depth x height), Space for 10-litre Thetford Porta Potti 335 WC (toilet not included), fittings necessary for anchoring to the vehicle, built-in footboard guide with stainless steel finish. (footboard not included) and table guide incorporated in the front of the cabinet (table not included)
Side Panel Kit
Side panels that are valid for both T5, T6 and T6.1, these panels are very easy to install and uninstall, IMPORTANT: as furniture manufacturers we emphasize that the mechanical fastening elements (screws), location and quantity that are supplied with this product, are only at the level of recommendation, the competent technician and/or accredited laboratory that legalizes this installation will determine if it is necessary to change and/or modify the anchoring system proposed by Furgomania, the product requires LEGALIZATION.
4-in-1 kit with fridge
The 4-in-1 Kit is the ideal complement to any VW van bed kit, it is installed without the need for tools, by attaching this module you will have the wonderful Waeco CD-30 refrigerator, undoubtedly one of the best compressor refrigerators on the market, efficiency and autonomy are assured, it also has a large drawer under the refrigerator, It can accommodate the portable kitchen and many other utensils, it also has a folding table that can be extended from the outside. Cheap camper vans
4-in-1 Kit with Sink
4-in-1 cabinet with sink to be installed to replace the single-seater armchair that is located next to the sliding door, the cabinet consists of two 12-litre tanks in addition to all the small accessories necessary for the operation of the sink. This piece of furniture is connected to a 12-volt cigarette lighter socket for the operation of the electric pump and does not need to install a second battery in the vehicle.
4-in-1 WC Kit
The 4-in-1 Kit is the ideal complement to any Furgomania bed kit for Voklswagen Transporter Kombi T5/T6, it is installed without the need for tools, in place of the single armchair in the second row of seats, it unfolds outwards a folding table that gives great service and comfort.
It includes a 10-litre Thetford Qube 335 Chemical Toilet and toilet already installed that is perfectly hidden under the lid of the chest and a large drawer in which all kinds of objects and utensils can be transported.
4-in-1 Chest Kit
The 4-in-1 Kit is the ideal complement to any Furgomania bed kit, it is installed without the need for tools, attaching this module in addition to extending your bed, you will have extra capacity thanks to the large dimensions of the chest in which you can put bulky objects, such as a chemical toilet or portable fridge, You decide what to do with the space, it also has a folding table that can be extended to cook from the outside. The interior measurements of the chest are 46 cm high, 59 cm long and 44.5 cm wide.
Universal indoor outdoor table kit
Universal table for both indoor and outdoor use with tubular central support with tripod, the table measures 120 cm long by 40 cm wide. The kit consists of a painted table top + tripod with support tube + conical support + protective storage cover + two tie-down straps
Front Table Kit
This simple kit brings a lot of utility to your van Both when you use it as a camper van and on a day-to-day basis, as all the kits we offer you are self-installable, in a few minutes and only by fixing four screws you can enjoy the comfort of the table that is removable, the table due to its size cannot be folded in the bulkhead where it is installed since it measures 80 cm long by 40 cm wide and where it is installed, There’s no room to fold it up.
Normally this table is installed in the left bulkhead of the van, which is where we do not have a sliding door, but if on that side we have a sliding door, it is also possible to install it, you just need to corroborate that when we open the sliding door it separates from the vehicle more than 2 cm, which is the space occupied by the table guide, since otherwise the table guide will rub against us on the outside of the van. the van.
Outdoor Rear Table Kit
The Rear Table Kit It is one of the bed tops converted into a table, we simply add 4 threaded legs and some locks that are used to store the legs when we transport the table as a bed surface, it is a double use that we give to one of the surfaces of your bed kit, allowing you to use a multifunctional table both inside and outside the camper van.
The size of the table will depend on the bed kit we have chosen, as well as the height at which the table is with respect to the floor, since the height of the table is a function of the size of the table.
Add Footboard
The footboard is an optional that you can add to both the basic bed kit and the wide module bed kit, it is an option that you can add when buying the bed kit or later.
This option allows you to keep the rear seats and remove them at any given time and thus have more space in the central area of the vehicle. You can also add an optional one to the footboard that allows you to form a table.
When we use it as a footboard it is supported on two legs of bed height and when we use it as a table it is supported on another four legs of table height that we can use both inside and outside the van.
Normally the footboard is manufactured with the necessary dimensions so that the bed has a total length of 190 cm. Another peculiarity of the footboard is that we can manufacture it with two types of folding, we can manufacture it with a lower fold that acts as a loading bulkhead or we can configure it with an upper fold that allows us to have a longer length of load under the bed, a length that we sometimes need, for example, to be able to put surfboards or any other object that needs the entire length of load under the bed of our camper van.
Water tank
El depósito de agua es un opcional que siempre recomendamos, se trata de unas sencillas garrafas que pueden ser de 11, 16 o 19 litros dependiendo del espacio disponible en cada kit de cama.
En ciertos modelos de kits de cama permite meter un depósito dentro de cada módulo aunque en la gran maría de los casos solo es posible llevar un solo depósito dentro del módulo derecho del vehículo en un hueco específicamente diseñado para este propósito, este hueco lo hemos impermeabilizado con una pintura especial en su parte inferior para evitar humedades.
Hay clientes que adquieren varios depósitos y los ponen debajo de cama para así disponer de mayor autonomía. Los sistemas de ducha no los vendemos debido a su gran variedad de precios y calidades en el mercado, el sistema de ducha reflejado en este opcional es meramente representativo, no se incluye ni los tenemos disponibles.
Drawer Kit
The Drawer Kit It is an optional that is a large drawer that we can put under the bed both in the basic bed kits and in the wide module kits and also in the third row kits, the drawer will have in each case the necessary dimensions to fit under the bed and will always have the maximum width and length that the bed kit allows. The drawer has a height of 20 cm on the outside and 18 cm on the inside.
By putting this drawer under the bed it gives us the possibility of dividing the cargo area into two spaces, on the one hand we will have a drawer and under it we have about 30 cm of height for the rest of the load we need to carry.
This drawer is usually combined with the optional access hatch that allows us to access the drawer from inside the vehicle simply by lifting one of the mattresses from the bed (recommended)
Access hatch
Access hatches They are very useful to take things under the bed without having to leave the vehicle, from these hatches three units can be installed, one on each bed board, but we consider that it is an unnecessary expense, most of our customers opt to place one on the central board of the bed although the ideal is to have one at each end but one is usually enough, It all depends on the number of objects we have under the bed and how we have them placed.
It should be added that the board that has the access hatch can be moved without any problem and in this way we also change the location of the access hatch.
This option is highly recommended when combined with the large drawer kit that we place under the bed since access to the drawer is greatly facilitated through this hatch.
Universal Tripod
This option consists of adding a leg with a tripod-shaped base To one of the boards of the bed and thus achieve a second function with one of the boards of the bed, under the board is attached a base with conical lace where we introduce the tube that acts as a central leg and in the base is attached a tripod-shaped one that provides very good stability both for use inside the van and outside, This whole set is served in a practical bag that we can easily store since the tripod-shaped base folds in on itself.
Attached Outdoor Table Kit
Detachable table to be installed at the rear of the vehicle.
The kit consists of a table 80 cm long by 40 cm high, a folding leg adjustable in height, a table guide that is installed on the furniture and a cover where you can store the table.
The product is shipped with the table guide disassembled so that you can adapt it to your vehicle depending on the rear height of the vehicle.
This same table, by acquiring another guide, can also be used inside the vehicle, we will simply need to install the table guide wherever we want to use it.