Basic Bed Kit

The Basic Bed Kit is the most requested option of our van beds, it is an excellent solution to camper your Volkswagen Transporter Kombi T5 and T6 van for very little money, in a few minutes without the need for tools and without the need to homologate in the I.T.V.

The Basic Bed Kit for VolksWagen Transporter Kombi Camper T5 and T6 can be complemented with one of the 4-in-1 kits that will provide a lot of service to your camper van, you can see them below on this page and with the shower system with electric pump, it is always very practical to have clean water for the toilet.

Wide Module Bed Kit

The Bed Kit with wide module is similar to the Basic kit for Volkswagen Transporter Kombi Camper T5/T6 the difference is that we have replaced one of the side modules with a much wider one, distributing the space to be able to house a WAECO CF26 fridge, this fridge is not supplied by Furgomania, you can buy this model of fridge and easily install it in the space intended for it. All the details have been taken care of, such as providing the module with the necessary ventilation grilles for the operation of the fridge and the accesses for the cables.

By having a larger capacity, this module has made it possible to distribute its compartments in such a way that a large water tank can also be housed and there is much more space to carry all the necessary objects in an organized way.

Like the Basic kit, it can be installed without the need for tools and without having to be approved by the I.T.V. Easy-to-install van beds

Kitchen cabinet with sink, drawers and toilet space

Kitchen cabinet with 0.7 mm laminated worktop, scratch-resistant and waterproof, 100% with Dometic sink with glass lid, 42 cm diameter, two 19-litre tanks with submersible pump (included) with waterproofing of the storage area, two pull-out drawers 40 x 40 x 12 (width x depth x height), Space for 10-litre Thetford Porta Potti 335 WC (toilet not included), fittings necessary for anchoring to the vehicle, built-in footboard guide with stainless steel finish. (footboard not included) and table guide incorporated in the front of the cabinet (table not included)

Baul doble para camperizar

Double trunk behind driver

The double trunk behind the driver is designed for those people who need a lot of load capacity, the interior is divided into two spaces but you can eliminate the interior division only by removing it from its rails and thus have an ideal open space to put larger objects. This kit is usually combined with the optional footboard since when removing the armchairs from the second row we need a base that acts as an extension of the bed kit to obtain the desired bed length, which is normally 190 cm. This kit is attached to the van in the same way as the bed kits, i.e. by means of tensioners with chains that are hooked to the load fastening eyes that the van comes with from the factory.

Kit panel lateral Volkswagen

Side Panel Kit

Side panels that are valid for both T5, T6 and T6.1, these panels are very easy to install and uninstall, IMPORTANT: as furniture manufacturers we emphasize that the mechanical fastening elements (screws), location and quantity that are supplied with this product, are only at the level of recommendation, the competent technician and/or accredited laboratory that legalizes this installation will determine if it is necessary to change and/or modify the anchoring system proposed by Furgomania, the product requires LEGALIZATION.

4-in-1 kit with fridge

The 4in1 Kit is the ideal complement to any Furgomania bed kit for Volkswagen Transporter Kombi T5/T6, it is installed without the need for tools, the kit is attached to the vehicle by means of a metal fitting that hooks at the bottom with the bed kit, it takes the place of the single chair in the second row of seats, It folds out to the outside a folding table that gives great service and comfort, for example for cooking with a portable cooker.

The kit includes the Waeco CD-30 drawer fridge although we also installed the Vitifrigo which are of somewhat better quality, undoubtedly the best compressor fridges on the market, efficiency and autonomy are assured, it also has a large drawer at the bottom, in which you can accommodate a portable kitchen (not included) or any object you need to carry.

Kit 4 en 1 fregadero furgomania

4-in-1 Kit with Sink

4-in-1 cabinet with sink to be installed to replace the single-seater armchair that is located next to the sliding door, the cabinet consists of two 12-litre tanks in addition to all the small accessories necessary for the operation of the sink. This piece of furniture is connected to a 12-volt cigarette lighter socket for the operation of the electric pump and does not need to install a second battery in the vehicle.

4-in-1 WC Kit

The 4-in-1 Kit is the ideal complement to any Furgomania bed kit for Voklswagen Transporter Kombi T5/T6, it is installed without the need for tools, in place of the single armchair in the second row of seats, it unfolds outwards a folding table that gives great service and comfort.

It includes a 10-litre Thetford Qube 335 Chemical Toilet and toilet already installed that is perfectly hidden under the lid of the chest and a large drawer in which all kinds of objects and utensils can be transported.

4-in-1 Chest Kit

The 4-in-1 Kit is the ideal complement to any Furgomania bed kit for Voklswagen Transporter Kombi T5/T6, it is installed without the need for tools, in place of the single armchair in the second row of seats, it unfolds outwards a folding table that gives great service and comfort.

It includes a spacious chest that will allow you to store and transport all kinds of objects and utensils, the interior measurements of the chest are 46 cm high, 59 cm long and 44.5 wide.

Universal indoor outdoor table kit

This table is a kit that is valid for any camper van and especially recommended for those with three front seats and the impossibility of being able to rotate these armchairs. It consists of a 120 cm long by 40 cm wide board with chamfered vertices to facilitate access from sliding doors, whether they are two or just one door. The holes have been designed so that the user can hold the table in the event that for some reason they need it. The kit consists of a painted table top + tripod with support tube + conical support + protective storage cover + two lashing straps.

Front Table Kit

This simple kit brings a lot of utility to your van both when you use it and when you use it. Camper van As in the day to day, as all the kits we offer you are self-installable, in a few minutes and only by fixing four screws you can enjoy the comfort of the table that is removable, the table due to its size cannot be folded in the bulkhead where it is installed since it measures 80 cm long by 40 cm wide and where it is installed, There’s no room to fold it up. Normally this table is installed in the left bulkhead of the van, which is where we do not have a sliding door, but if on that side we have a sliding door, it is also possible to install it, you just need to corroborate that when we open the sliding door it is separated from the vehicle more than 2 cm, which is the space occupied by the table guide, since otherwise the table guide will rub against us on the outside of the van. the van.

Outdoor Rear Table Kit

The Back Table Kit is one of the bed tops converted into a table, we simply add 4 threaded legs and some locks that are used to store the legs when we transport the table as a bed surface, it is a double use that we give to one of the surfaces of your bed kit, allowing you to use a multifunctional table both inside and outside the Campervan. The size of the table will depend on the bed kit we have chosen, as well as the height at which the table is with respect to the floor, since the height of the table is a function of the size of the table.

Add Footboard

The footboard is an optional that you can add to both the basic bed kit and the wide module bed kit, it is an option that you can add when buying the bed kit or later. This option allows you to keep the rear seats and remove them at any given time and thus have more space in the central area of the vehicle. You can also add an optional one to the footboard that allows you to form a table. When we use it as a footboard it is supported on two legs of bed height and when we use it as a table it is supported on another four legs of table height that we can use both inside and outside the van. Normally the footboard is manufactured with the necessary dimensions so that the bed has a total length of 190 cm. Another peculiarity of the footboard is that we can manufacture it with two types of folding, we can manufacture it with a lower fold that acts as a loading bulkhead or we can configure it with an upper fold that allows us to have a longer length of load under the bed, a length that we sometimes need, for example, to be able to put surfboards or any other object that needs the entire length of load under the bed of our camper van.
Kit ducha furgoneta

Water tank

The water tank is an option that we always recommend, it is a simple jug that can be 11, 16 or 19 liters depending on the space available in each bed kit. In certain models of bed kits it allows a tank to be placed inside each module, although in most cases it is only possible to carry a single tank inside the right module of the vehicle in a hole specifically designed for this purpose, this hole has been waterproofed with a special paint on its lower part to avoid dampness. There are customers who buy several tanks and put them under the bed in order to have more autonomy. We do not sell shower systems due to their wide variety of prices and qualities in the market, the shower system reflected in this option is merely representative, it is not included nor do we have them available.

Kit de cajón

Drawer Kit

The drawer kit is an optional one that is a large drawer that we can put under the bed both in the basic bed kits and in the wide module kits and also in the third row kits, the drawer will have in each case the necessary dimensions to fit under the bed and will always have the maximum width and length that the bed kit allows. The drawer has a height of 20 cm on the outside and 18 cm on the inside. By putting this drawer under the bed it gives us the possibility of dividing the cargo area into two spaces, on the one hand we will have a drawer and under it we have about 30 cm of height for the rest of the load we need to carry. This drawer is usually combined with the optional access hatch that allows us to access the drawer from inside the vehicle simply by lifting one of the mattresses from the bed (recommended)

Access Covers

Access hatch

The access hatches are very useful to take things under the bed without having to leave the vehicle, of these hatches three units can be installed, one on each bed board, but we consider that it is an unnecessary expense, most of our customers opt to place one on the central board of the bed although the ideal is to have one at each end but one is usually enough, It all depends on the number of objects we have under the bed and how we have them placed. It should be added that the board that has the access hatch can be moved without any problem and in this way we also change the location of the access hatch. This option is highly recommended when combined with the large drawer kit that we place under the bed since access to the drawer is greatly facilitated through this hatch.

camperizar furgoneta Tripode universal

Universal Tripod

This option consists of adding a leg with a tripod-shaped base to one of the tables of the bed and thus achieve a second function with one of the boards of the bed, under the board a base with conical lace is attached where we introduce the tube that acts as a central leg and in the base a tripod-shaped one is attached that provides very good stability both for its use Inside the van as well as outside, all this set is served in a practical bag that we can easily store since the tripod-shaped base folds on itself, an additional option to camper your van.

KIT MESA EXTERIOR ADOSADA

Attached Outdoor Table Kit

Detachable table to be installed at the rear of the vehicle. The kit consists of a Table 80 cm long by 40 cm high, a folding leg adjustable in height, a table guide that is installed on the furniture and a cover where you can store the table. The product is shipped with the Disassembled table so that you can adapt it to your vehicle depending on its rear height. This same table, by acquiring another guide, can also be used inside the vehicle, we will simply need to install the table guide wherever we want to use it.